CHIRP In-Hull Transducers

Garmin's GT15M-IH In-Hull Mid-band CHIRP Transducer provides accurate depth readings and is compatible with Garmin STRIKER, echoMAP CHIRP, echoMAP Plus, echoMAP UHD, GPSMAP chartplotter/sonar combination units and GSD25.

Garmin GT8HW-IH In Hull CHIRP Transducer is designed to be mounted inside the hull of your boat. This 250 Watt Transducer can reach maximum depths of up to 800'. Transducer comes with 20' transducer cable with Garmin 8-pin connector.
Designed for boats with less than a 6° deadrise

The Airmar M265C-LH Chirp Transducer uses Broadband CeramicTechnology for crystal clear image detail and resolution. Increased resolution allows you to easily distinguish individual fish targets in the water column or close on the bottom. (Low and High Frequencies, Depth Only) No Connector, For Bare Wire Install.

The Garmin M265C-LH is a top performing, 1kW In-Hull Transducer providing crystal clear underwater detail. Reaching 3,000' the M265 CHIRP operates at a frequency of 42 to 65 kHz and 130 to 210 kHz; a beamwidth of 16 to 25 degrees or 6 to 10 degrees; and a 0 to 30 degree deadrise.

Airmar 1kW in hull, wide-beam, high-frequency CHIRP transducer. Navico 9-Pin XSonic Mix and Match Cable Included. Designed for boats up to 36' with a solid-fiberglass hull. The M285C-HW-9N does not provide speed or water temperature.

The Airmar PM265LM CHIRP pocket mount transducer is a 1kW transducer with Navico (Simrad or Lowrance) 9-Pin Y-Cable Connector.

The Airmar R599LH is a 2-3kW low and high frequency transducer delivering deep water performance down to 10,000'. The R599LH is an in-hull design and includes a tank which is cut to the boat's deadrise post purchase and affixed inside the hull.