Free 2-Day Shipping on Thousands of Items!
Garmin Bail Mount and Knobs for GPSMAP 7407, 7407xsv, 7607 and 7607xsv.
Garmin Bail Mount and Knobs for GPSMAP 7410, 7410xsv, 7610 and 7610xsv.
Flush Mount your Garmin STRIKER 4 with this kit. Includes Mounting Template, Hardware and Instructions.
Garmin Protective Cover for 9" echoMAP units. Compatible with Garmin echoMAP 93sv, 94sv, echoMAP CHIRP 92sv, 93sv,94sv and 95sv. Does not work with PLUS or UHD models
Icom BC-217SA/SE USB Charger for M25 and M37. Charge your Icom M25 or M37 Handheld VHF in 3 hours from a 110v outlet using the BC 217SA.
Garmin adapter cable connects a 12-pin transducer to a 4-pin sounder
Provide Protection for your Lowrance Elite 4x, Elite 4, Mark 4 or Hook 4 and 4x GPS/Fishfinder with this Suncover. *Compatible with HDI Series of units only.
Fusion Flush Mount USB Cable
Use this wire block to adapt your bare wire transducer to a 12-Pin Garmin connector.
Lumishore's SMX11 Surface Mount Underwater LED Lights add bright underwater lighting to your vessel and are easy to install. Perfect for above or below the water line, the SMX-11 provides 60 degrees of light while only drawing 1 amp current from 12v.
Navico 10-Foot 12-PIN Transducer Extension cable for StructureScan 3D Module and 3D Bundles. Includes 2 10' (3M) cables.
Icom HM-228 IPX7 Waterproof Speaker Mic for M93D and M94D. Compact Design.
Garmins 9 Axis Heading Sensor provides accuracy +/- 2°. 10Hz Output Rate ensures your chart orientation and boat heading is accurate with reality. Premium Heading Accuracy at low speeds and even when bow is pitching, rolling or heeling over.
Flush Mount your Garmin GPSMAP 922, 922xs, 942 or 942xs with the 010-12546-01 Flush Mount Kit. Includes Hardware, Template and Installation Instructions.
Furuno F-Type (Front Mount) Flush Mount Kit for Furuno GP39
The Garmin Marine Network Cable Connector gives you the ability to wire on the connector after you have run the cable through your boat. Sold in a pack of two.
The Navico XSONIC Transducer Adapter Cable Connects 7 pin blue plug transducers to the 9 pin XSONIC black sockets on select Lowrance and Simrad displays.
Garmin NMEA 2000 Multiport T-Connector.
Garmin Protective Cover for echoMap Plus 42cv, 43cv, 44cv and 45cv units.
Garmin Protective Cover for echoMap Plus and ECHOMAP UHD 62cv, 63cv, 64cv and 65cv units.
Garmin Tilt/Swivel Mount for STRIKER Plus and STRIKER Vivid 4 and 4cv Units.
Garmin Tilt/Swivel mount with Quick Release Cradle for echoMAP Plus and echoMAP UHD 72sv, 73sv, 74sv and 75sv.
7" echoMAP Plus SideVu (sv) Models only!
Protect your Lowrance HOOK2 9" and HOOK Reveal 9" Display from the elements with this Sun Cover. Compatible with 9" HOOK2 SplitShot and TripleShot units along with HOOK Reveal 9" Displays.
Protect your Lowrance HOOK2 4x Display from the elements with this Sun Cover. Compatible with HOOK2 4x units.
Protect your Lowrance HOOK2 12" Display from the elements with this Sun Cover. Compatible with 12" HOOK2 TripleShot units.
Navico Quick Release Bracket for Lowrance HOOK2 4" and 5" Displays, HOOK Reveal 5" Displays and Eagle 4x Display.
Raymarine's A80490 adapter cable is required for all CPT-S tranducers to connect to an Axiom RV, Axiom Pro S, Axiom 2 Pro S and an Axiom Pro RVX. 9 pin connection from CPT-S transducer will plug into the 25 pin connection on the MFD.
Lowrance Gimbal bracket for All HOOK2 and HOOK Reveal 9" Units. Includes Knobs.
With the Yamaha to J1939 Adapter Cable you can have your compatible Yamaha engine data fully integrated with your J1939-equipped GPSMAP Chartplotter. Cable is approximately 3 feet long.
Keep your Standard Horizon HX40 Handheld VHF from sinking with this bright orange floating case! Slip on to your HX40 and keep it afloat if it falls overboard.
Lumishore's SUPRA i-Connect hub Switch works with the SUPRA SMX i-Connect Hub to control your SMX53 Lights. This low-profile dash mounted all in one on/off/momentary switch allows you to switch between light colors, Fade colors, strobe colors in 2 speed and adjust brightness. (Requires i-Connect Hub Junction Box to work)
The SUPRA SMX i-Connect Hub from Lumishore makes installing, operating and incorporating full light control of your SMX53 Lights a breeze. Centralizing all light and switch connections, this Hub pairs with the SUPRA i-connect switch for full control.
The Standard Horizon SCU30 is a wireless access point that provides the ability to add up to 4 RAM4/RAM4X Wireless Microphones.
The Airmar 6-Conductor Splice makes splicing 6-strand wire together fast, easy, clean and secure.
The Garmin Verado Adapter Kit is used for plumbing your Garmin Hydraulic Autopilot to your Mercury Verado Engine Steering System.
The Garmin SeaStar Fittings Kit is used for plumbing your Garmin Hydraulic Autopilot to most SeaStar Steering System.
Raymarine's A80542 Passive Speaker pairs with your wired handset to provide crystal clear audio from your compatible VHF. Rugged and Waterproof.
The ACR RCL-85 LED Searchlight with 240,000 candela using 6 High Flux (30W) LED’s provide over 1/2 nm of lighting. Simple Install – connect to 12 to 24 volt power and you’re ready to go! Includes wireless handheld remote to rotate light 350°.
The ACR RCL-95 LED Searchlight with 460,000 candelas using 10 High Flux (50W) LED’s provide over 3/4 nm of lighting. Simple Install – connect to 12 to 24 volt power, wire up the joystick and you’re ready to go! Includes wireless handheld remote as well as dash mount with joystick to rotate light 360°.
The Seaview Forward Raked Radar Mounting Base is not only stylish but also very sturdy and provides a base to mount the Seaview Radar Plate to.
*Mounting Plate Required.
Garmin's ECHOMAP Plus 7xsv Boat kit comes with everything you need for a second station setup. Includes GT52HW-TM Transducer, Tilt/swivel mount with quick-release cradle and Power/data cable.
The Seaview Mast Mount provides a very sturdy platform for your compatible radar.
Lowrance 7 Pin Transducer to Hook2 and Reveal Fishfinder Adapter Cable.
Take full control of your Lumishore lighting directly from your EOS-LUX SUPRA display. The dedicated glass touch screen and rotary dial give you full control of you vessels compatible underwater lights.
Connect a Garmin GT30 transom mount scanning transducer and a Garmin GT8HW-IH, GT15M-IH, Airmar P79 in-hull mount traditional transducer to a compatible ECHOMAP Plus, echoMAP CHIRP chartplotter/sonar combo or a GPSMAP 10X2xsv/12X2xsv chartplotter.
The SBH-36 is the replacement cradle for the Standard Horizon HX400 and HX400IS radios. The SBH-36 requires the use of the SAD-25B charging cable (not included and sold separately).
Icom Alkaline Battery pack for M37
The Standard Horizon SCU-38 Passive Antenna is compatible with the following Standard Horizon radios: GX1400G, GX1800G, GX1850G and GX2400. Please note that the SCU-38 is a passive antenna and will only work with units already equipped with a built-in GPS receiver.
