Garmin's mounting bracket enables you to mount your Garmin ECHOMAP UHD2 5- or 7-inch 'CV' series GPS. The Garmin bail mount is also compatible with select Garmin Striker fishfinders. See list below for full compatibility.
Garmin Marine Accessories
Garmin Bracket Mount with Quick Release Cable for 7" and 9" echoMAP CHIRP SV units. Does not work with PLUS or UHD models.
Expected 5/2/2024
Use this wire block to adapt your bare wire transducer to a 12-Pin Garmin connector.
Shipping!
Power your compatible Garmin Radar with this 48 foot long threaded cable.
Marine Network Cable PoE Isolation Coupler, Required when installing a FLIR camera on a Garmin Marine Network. Also requires an additional Garmin Marine Network Cable to connect from Coupler to MFD.
Allowing you to Surface Mount your Garmin ECHOMAP Ultra 12" GPS, this quick release bail mount includes the knobs and tilts for optimum viewing.
Shipping!
Garmin Bail Mount with knobs for 8416, 8416xsv, 8616, 8616xsv and 1643/1643xsv.
Expected 5/6/2024
Large, 5-Inch, high resolution touch display for your compatible Garmin autopilot. The GHC 50 has a sleek, edge-to-edge glass display that matches current, high-end Garmin GPSMAP chartplotters. Wired and wireless remote-controlled options, plus Ethernet and WiFi Connectivity make the GHC 50 an advanced autopilot instrument display!
Requires a compatible Garmin autopilot, sold separately.
Shipping!
The Garmin instrument display protective cover shields your Garmin instrument display from the elements. Compatible with GHC 20, GMI 20, GNX 20, GNX 21 and GNX Wind Displays.
Expected 5/2/2024
Network compatible Garmin devices with the 20 foot BlueNet Marine Network Cable.
Garmin's USB Card reader with USB-C adapter cable pairs with your compatible chartplotter and accepts up to 2 Full Sized SD Cards. Simplifies access to charts, software updates and ActiveCaptain® data. Compatible with GPSMAP 16x3, 8400, 8600, 9000 and 9200 Series Chartplotter/Fishfinders.
Shipping!
Garmin GA 38 remote gps antenna with 30' cable. Fits standard 1" marine mount.
Shipping!
The Garmin NMEA 2000 Male Terminator is used to begin or end the NMEA 2000 Backbone. It should be installed on one side of a Micro-Tee.
The Garmin NMEA 2000 Female Terminator is used to begin or end the NMEA 2000 Backbone. It should be installed on one side of a Micro-Tee.
This Garmin cable can be used as your NMEA 2000 backbone cable. Length 10 Meter. This cable can not be used as a drop cable.
Garmin 10' Transducer Extension Cable for 4-Pin Transducers.
Garmin Protective Cover for 9" echoMAP units. Compatible with Garmin echoMAP 93sv, 94sv, echoMAP CHIRP 92sv, 93sv,94sv and 95sv. Does not work with PLUS or UHD models
Garmin adapter cable connects a Garmin 8-pin transducer to a Garmin 4-pin display including Garmin echo, echoMAP, echoMAP CHIRP, ECHOMAP UHD2, or STRIKER™ series fishfinder.
Garmins 9 Axis Heading Sensor provides accuracy +/- 2°. 10Hz Output Rate ensures your chart orientation and boat heading is accurate with reality. Premium Heading Accuracy at low speeds and even when bow is pitching, rolling or heeling over.
Expected 5/1/2024
Shipping!
Garmin's Bail Mount with Knobs enables your to Mount your GPSMAP 922, 922xs, 942 or 942xs to a flat surface. Includes tilt capabilities for best viewing.
in 3-5 Days
Garmin Protective Cover for echoMap Plus and ECHOMAP UHD 62cv, 63cv, 64cv and 65cv units.
Expected 5/3/2024
Garmin Tilt/Swivel mount with Quick Release Cradle for echoMAP Plus and echoMAP UHD 72sv, 73sv, 74sv and 75sv.
7" echoMAP Plus SideVu (sv) Models only!
With the Yamaha to J1939 Adapter Cable you can have your compatible Yamaha engine data fully integrated with your J1939-equipped GPSMAP Chartplotter. Cable is approximately 3 feet long.
Garmin's ECHOMAP Plus 9xsv Boat kit comes with everything you need for a second station setup. Includes GT52HW-TM Transducer, Tilt/swivel mount with quick-release cradle and Power/data cable.
Shipping!
Get the latest software update available from Garmin GPSMAP Series with this pre-programmed SD card.
Get the latest software update available from Garmin echoMAP Series with this pre-programmed SD card.
Garmin 6' Power/Data cable for all ECHOMAP Ultra units. Includes NMEA0183 Input/Output.
Protect your Garmin GPSMAP 10x2 series GPS display from scratches and sun when not in use!
in 3-5 Days
Protect your Garmin GPSMAP 8x12 series GPS display from scratches and sun when not in use!
Protect your Garmin GPSMAP 8x10 series GPS display from scratches and sun when not in use!
Protect your Garmin GPSMAP 7x3 series GPS display from scratches and sun when not in use!
Display Cover for 9" ECHOMAP UHD2 SV units - 92SV, 93SV and 94SV GPS/Fishfinders.
Does Not work with Garmin 9" Echomap Plus or UHD units
Mount your compatible Garmin LiveScope transducer to your Force Kraken trolling motor with this LiveScope mounting bracket. Conveniently route the LiveScope transducer cable through the shaft of the motor.
Shipping!
Garmin's Water Resistant, Floating Handheld Remote Control with sunlight readable display provides complete control of the the Force Trolling Motors. Point and Go Gesture Steering along with User Programmable Keys for control of your chartplotter.
Expected 5/8/2024
Shipping!
Garmin Kick Up Bracket for 010-10272-00 transducer(replacement)
Airmar Kick Up Bracket for P66 transom mount transducer(replacement). Works with any Airmar P66 transducer.
The Garmin NMEA 2000 Power Cable is used to power your NMEA 2K network through a standard NMEA2000 T-Connector.
Garmin NMEA 0183 Power/Data Cable
in 3-5 Days
Paired with a GHP20, GHP12 or Reactor Garmin’s GFR 10 will provide rudder position and detect and avoid rudder stops while on the water. Magnetic sensor relays position information so that you know where the rudder is without having to guess.
Order Now and Get Free UPS Ground Shipping!
Shipping!
Replacement Tilt / Swivel Mount for GPSMAP 547, 547XS and echoMap 50s Series.
Garmin 8-Pin Power/Data Cable for Select echoMAP and GPSMAP Series Chartplotter/Fishfinders.
Lost or Missing Protective Cover for your GPSMAP 5x7, 5x7xs or echoMap 50s Series? The Garmin 010-11971-00 is the exact protective cover that came with your unit originally.
in 3-5 Days
The Garmin GRID Garmin Remote Input Device offers maximum control of your GPSMAP 7x2, 7x2xs,9x2,9x2xs, 10x2, 10x2xs, 12x2,12x2xs, 7600, 7600xsv and 8000 Glass Helm series without ever touching the crystal clear glass display. Rotary knob and joystick enable you to easily navigate thru menus and screens on any number of networked displays.
in 3-5 Days
Shipping!
Looking for a replacement surface mount for your GPSMAP 720/740 series GPS Plotter/Sounder units. Garmin's 010-11483-00 is the exact mount that came with your unit originally. Includes Bail Mount and Knobs.
in 3-5 Days
The Garmin Step Mount for 4, 8, or 12 Pin Transducers allows you to mount a transom mount transducer in the step of your boat.
in 3-5 Days
Garmin 8-Pin 30' Transducer Extension Cable.
Garmin Bail Mount and Knobs for GPSMAP 7407, 7407xsv, 7607 and 7607xsv.
in 3-5 Days
Garmin Bail Mount and Knobs for GPSMAP 7412, 7412xsv, 7612 and 7612xsv as well as Garmin GPSMAP 1242/1242xsv TOUCH units.
in 3-5 Days