Airmar In-Hull Transducers

The Airmar PM265LM CHIRP pocket mount transducer is a 1kW transducer with Navico (Simrad or Lowrance) 9-Pin Y-Cable Connector.

The Airmar M265C-LH Chirp Transducer uses Broadband CeramicTechnology for crystal clear image detail and resolution. Increased resolution allows you to easily distinguish individual fish targets in the water column or close on the bottom. (Low and High Frequencies, Depth Only) No Connector, For Bare Wire Install.

This NMEA 2000 P79 In Hull (up to 22 degree deadrise) smart sensor provides digital depth to any existing NMEA 2000 network. The P79 includes a 6 Meter NMEA 2000 cable and NMEA 2000 T Connector.

Airmar 1kW in hull, wide-beam, high-frequency CHIRP transducer. Navico 9-Pin XSonic Mix and Match Cable Included. Designed for boats up to 36' with a solid-fiberglass hull. The M285C-HW-9N does not provide speed or water temperature.

The Airmar R599LM is a 2-3kW low to medium frequency transducer delivering deep water performance down to 10,000'. The R599LM is an in-hull design and includes a tank which is cut to the boat's deadrise post purchase and affixed inside the hull.

The Airmar R599LH is a 2-3kW low and high frequency transducer delivering deep water performance down to 10,000'. The R599LH is an in-hull design and includes a tank which is cut to the boat's deadrise post purchase and affixed inside the hull.

Airmar M260 traditional 1kW 50/200 kHz in-hull transducer. The M260 transducer provides depth only and includes the plastic housing and mounting tank. 6-Pin Garmin Mix and Match Cable Included.

Airmar P79 600W Plastic Dual Frequency In Hull Transducer. 6-Pin Garmin Mix and Match Cable Included.