Marine Accessories

The Seaview 5” Aft Mount with Plate and LED Light Bundle is designed for Starlink Antennas. This bundle is ideal for those looking to incorporate a light in their Starlink mount. This mount features a pre-dimpled hole pattern, water-tight gasket in the center of the plate and a 1” thick starboard plate that easily accommodates the included light bar.
Does Not Include Starlink, Sold Separately

The Seaview 5” Forward Mount with Plate Bundle is designed for Starlink Antennas. This mount features a pre-dimpled hole pattern and water-tight gasket in the center of the plate that allows for easy routing of the Starlink cable.
Does Not Include Starlink, Sold Separately

The Lowrance Active Imaging HD transducer provides Lowrance High/Medium CHIRP, SideScan and DownScan imagery. Enjoy Lowrance FishReveal DownScan and SideScan when paired with an S3100 sonar module, sold separately.

The Simrad RF25N rudder feedback is a medium duty rudder feedback that translates the angular travel of the rudder to a connected NMEA 2000 device. The RF25N connects via NMEA 2000 and features an attached 5.5m cable.

Mount your compatible Garmin LiveScope transducer to your Force Kraken trolling motor with this LiveScope mounting bracket. Conveniently route the LiveScope transducer cable through the shaft of the motor.

Garmin's Water Resistant, Floating Handheld Remote Control with sunlight readable display provides complete control of the the Force Trolling Motors. Point and Go Gesture Steering along with User Programmable Keys for control of your chartplotter.

The Garmin Nose Cone for Kraken trolling motors is designed to replace the standard part of your Force Kraken trolling motor or to install third-party accessories.

The Garmin GT12M-THF is a flush mount thru hull transducer with a 20-degree tilt, suitable for vessels with a deadrise of 16-24 degrees. The GT12M-THF is ideal for midsize fishing and cruising boats and features 350W mid-band CHIRP sonar.

The GRF 10 Rudder Feedback Cable extends the cable length 15 meters (49.2 feet).

The SiTex AIS Zero Loss Antenna Splitter Module allows for full use of VHF communications and AIS send/receive with a single VHF antenna. The MDA-3 is designed for use with Class B AIS Transceivers.

Power your compatible Garmin chartplotter or sonar module with this 2-pin, 6-foot power cable. See compatibility list below.

The 60A Garmin Circuit Breaker is used when installing a compatible Force Trolling Motor.

Connect your Alpha Performance Display to a Raymarine Axiom Chartplotter using this single cable that serves as both power and data (Raynet). This single cable design means less cabling running through the deck and mast, resulting in a simple and fast installation!
Cable Length: 1M

The Garmin BlueNet 30 Gateway allows legacy Garmin marine devices to network with Garmin BlueNet network units.

The Raymarine EV-1 is an evolution autopilot sensor core for traditional steering systems. This intelligent EV sensor core monitors vessel motion in three dimensions.

The Raymarine RNS-8 is a network switch allowing for easy networking of your compatible Raymarine components. This 8 port Gigabit RayNet network switch includes 4 dedicated power-over-ethernet (POE) ports. Integrate Axiom displays with radars, sonar modules and FLIR thermal cameras with ease!

Garmin Bail Mount with Quick Release for Echomap Ultra 2 12" Displays. Compatible with echomap Ultra 2 122sv & 126sv.

The Raymarine ECI-100 Universal Engine and Control Interface bridges engine instrumentation and drive-by-wire steering with Raymarine autopilot and navigation systems. This simple, single point of connection integrates Raymarine’s latest generation of MFD’s and provides autopilot steering interface to Evolution EV-2 Drive by Wire autopilots.

Garmin's USB Card reader with USB-C adapter cable pairs with your compatible chartplotter and accepts up to 2 Full Sized SD Cards. Simplifies access to charts, software updates and ActiveCaptain® data. Compatible with GPSMAP 16x3, 8400, 8600, 9000 and 9200 Series Chartplotter/Fishfinders.

Add some extra cable to your compatible Garmin VHF radio with this 12-pin, 10-meter fist mic extension cable. See compatibility list below.

Protect your Lowrance 5-inch Eagle display from the elements with the Lowrance protective cover!

The Lowrance Eagle SplitShot transducer is designed exclusively for the Lowrance Eagle series and provides wide-angle high CHIRP and DownScan imaging. FishReveal technology provides unparalleled target separation and identification!

Flush mount your 5-inch Lowrance Eagle display with the dash mounting kit!

Navico's emergency Man-Over-Board (MOB) button is simple to install and connects to your compatible device via NMEA2000. By simply pressing the button, a MOB waypoint will automatically be created and provide navigation data to reach the MOB position.

Icom MBF-9 Flush Mounting Bracket for M510 Series VHF Radios.

Raymarine's RCR-1 USB microSD card reader provides remote microSD access to Axiom, Axiom+, Axiom Pro, Axiom Pro 2, and Axiom XL chartplotter displays. Designed to make accessing the microSD card slot easier, The RCR-1 is recommended for Axiom and Axiom+ installations when the rear microSD card reader is not readily accessible. Axiom XL installations require an RCR-1 or RCR-SD USB for microSD card access.

Control autopilot, anchor, cruise control, drop a waypoint and control prop on/off features with the Lowrance Compact GPS Remote for trolling motors. This easy-to-wear remote is lightweight features an ergonomic design. Compatible with Lowrance and Simrad Recon Trolling Motors.

This Furuno Cable will allow you to connect two TZTouchXL units together or connect to a network hub. 5M total length with Waterproof RJ45 connectors on both ends.

This Furuno Cable will allow you to connect two TZTouchXL units together or connect to a network hub. 10M total length with Waterproof RJ45 connectors on both ends.

The Airmar Crows Foot Wrench is designed to facilitate installation of compatible transducers by holding the transducer in place while the nut is being tightened. The Crows Foot Wrench is compatible with B164/SS164 and B175/SS175 transducers.

The Lowrance Eagle Power Cable is compatible with 5"/7"/9" Eagle and Eagle Eye Displays.

This Furuno Cable will allow you to connect two TZTouchXL units together or connect to a network hub. 10M total length with One Waterproof RJ45 connector and one Non-Waterproof RJ45 Connector.

Need Additional Network Ports for your Furuno MFD Setup? The HUB-102-JMP with waterproof RJ45 connections connects two Furuno HUB102's together providing additional network ports. 0.5 Meter Length.

The Garmin Transducer Replacement Kit allows you to easily replace or upgrade the built-in transducer on your Garmin Force Kraken trolling motor. Does not include Nose Cone.
Not Compatible with Garmin Force Trolling Motors

The MMR-20-BE is a round, wired remote controller, compatible with MediaMaster. This non-display remote controller adds auxiliary control to MediaMaster source units. The weatherproof (IP67) design is built for the elements and is ideal for both day and night use! The MMR-20-BE is compact in size and ideal for even the tightest spaces.

The JL Audio Connection Cable allows you to easily connect non-NMEA 2000 remote controllers with a MediaMaster source unit. The JL Audio MMC-25 cable is 25 feet long.

The Raymarine Active Wireless Speaker is designed for high-noise areas. The rugged and waterproof housing is designed with vertical or horizontal mounting options. This active speaker is compatible with the Ray 63, 73, 90 and 91 VHF Radios.

Gain control of your autopilot with the APK Keypad! This intuitive keypad features a simple knob and button control making it easy to adjust your heading. Engage or put your autopilot into standby with the simple push of a button. Add additional autopilot functions based on your preferences. Connect the APK 10 via simple NMEA 2000.
Available in Horizontal or Vertical Orientation. Choose Orientation Below.

The Green 8-Pin Male to RJ45 Cable is compatible with the NEP-3 Port Expander. Cable measures 1.8m (6ft).

The Airmar Mix & Match Cable for 12-Pin CHIRP Series with Furuno 12-Pin Connector is 1m in length and connects to your compatible Airmar transducer with a 12-pin Mix and Match connector and provides a Furuno 12-pin plug on the other side. This cable is compatible with Furuno CHIRP, 12-pin transducers.

The Airmar Mix & Match Cable for 12-Pin CHIRP Series with Furuno 12-Pin Connector is 1m in length and connects to your compatible Airmar transducer with a 12-pin Mix and Match connector and provides a Furuno 12-pin plug on the other side. This cable is compatible with Furuno Single Band Low Frequency CHIRP, 12-pin transducers.

The Airmar Mix & Match Cable for 12-Pin CHIRP Series with Garmin 12-Pin Connector is 1m in length and connects to your compatible Airmar transducer with a 12-pin Mix and Match connector and provides a Garmin 12-pin plug on the other side. 

The Airmar Mix & Match Cable for 12-Pin CHIRP Series with Humminbird 14-Pin Connector is 1m in length and connects to your compatible Airmar transducer with a 12-pin Mix and Match connector and provides a Humminbird 14-pin plug on the other side.

The Airmar Mix & Match Cable for 12-Pin CHIRP Series with Navico 9-Pin Connector is 1m in length and connects to your compatible Airmar transducer with a 12-pin Mix and Match connector and provides a (2) Navico 9-pin plugs on the other side (Y-Cable).

The Airmar Mix & Match Cable for 600W Navico Blue is 8m in length and has a 5-pin 600W Mix and Match end on one side and a Navico 7-pin Blue connector on the other side.

The Airmar Mix & Match Cable with Raymarine DSM Connector is 9m in length and has a 5-pin 600W Mix and Match end on one side and a Raymarine DSM connector on the other side.

The Seaview Light Bar is a 1.25" diameter aluminum tube powder coated white to match your Seaview Modular Mount. Move your Navigation light above your radar so you can be seen during night hours.
Color: Black

The Scanstrut Ultra is a Qi2-certified, MagSafe-compatible, marine-grade phone charger featuring an IPX6 waterproof rating and toughened glass. Apple phones magnetically lock into the optimal charging position providing a secure connection and fast charging! This sleek, low-profile charger eliminates cable clutter and provides a strong magnetic grip, ideal for rough seas!