Garmin Marine Accessories

Garmin’s GPS24XD NMEA2000 GPS antenna provides multi-band GNSS accuracy to 1M. The magnetic heading sensor provides accuracy to within 3 degrees with enhanced stabilization at slow speeds. Includes under-deck, pole and surface mount options.

The Garmin NMEA 2000 Starter Kit comes with all of the parts you need to start a NMEA2000 Marine Network.

Garmin Marine Network Cable (6').

Garmin Protective Cover for ECHOMAP Ultra 122sv and 126sv.

The Garmin 2-Pin Threaded Power Cable is compatible with ECHOMAP UHD2 6-Inch, 7-Inch SV and 9-Inch Displays and measures 6 feet long.

Garmin GMS 10 Network Port Expander will add 5 Network ports to your Garmin network.

This cable can be used as your NMEA 2000 backbone or drop cable. Length 2 Meter

Garmin NMEA 2000 Multiport T-Connector.

Allowing you to Surface Mount your Garmin ECHOMAP Ultra 12" GPS, this quick release bail mount includes the knobs and tilts for optimum viewing.

Garmin Bail Mount with knobs for 8416, 8416xsv, 8616, 8616xsv and 1643/1643xsv.

The Garmin Bail Mount with Quick Release Cradle for ECHOMAP UHD2 9-Inch SV Displays tilts for optimum viewing. All cables plug into the mount's quick release cradle making it quick and easy to remove your display while leaving all cables plugged into the cradle.

The Garmin GFS 10 Fuel Sensor provides fuel flow and fuel level measurement data. You can view this information on your compatible Garmin NMEA2000 compliant chartplotter, GPS/FF combo or GMI 10 display.

The Garmin NMEA 2000 T-Connector is required for adding components to your network. It is installed on the backbone cable and uses one end of the T-Connector for the drop cable.

Garmin 8-Pin Power/Data Cable for Select echoMAP and GPSMAP Series Chartplotter/Fishfinders.

Garmin Bracket Mount with Quick Release Cable for 7" and 9" echoMAP CHIRP SV units. Does not work with PLUS or UHD models.

Garmin Marine Network Cable (20').

Garmin's 4-Pin Power/Data Cable. 6Ft Cable includes NMEA0183 inputs/outputs.

Garmin Bail Mount and Knobs for GPSMAP 7416, 7416xsv, 7616 and 7616xsv.

Garmin Tilt/Swivel mount with Quick Release Cradle for echoMAP Plus and ECHOMAP UHD 62cv, 63cv, 64cv and 65cv.

Garmin Protective Cover for ECHOMAP Ultra 102sv and 106sv.

Protect your Garmin GPSMAP 9x3 series GPS display from scratches and sun when not in use!

Protect your Garmin GPSMAP 8x16 series GPS display from scratches and sun when not in use!

Protect your Garmin GPSMAP 8x12 series GPS display from scratches and sun when not in use!

Garmin Protective Cover for echoMap Plus and UHD 72cv/sv, 73cv/sv, 74cv/sv and 75cv/sv units.

The Garmin instrument display protective cover shields your Garmin instrument display from the elements. Compatible with GHC 20, GMI 20, GNX 20, GNX 21 and GNX Wind Displays. 

Quickly and Easily install or uninstall your Force Kraken Trolling Motor with this Quick Release Plate System.
Available in Black Or White

Garmin GA 38 remote gps antenna with 30' cable. Fits standard 1" marine mount.

Garmin Power Cable for 720s and 740s Chartplotter/Sounders. Replacement part.

The Garmin NMEA 2000 Power Cable is used to power your NMEA 2K network through a standard NMEA2000 T-Connector.

Garmin Power/Data Cable for 7-Pin Chartplotters. Replacement part.

Connect 2 Marine Network cables end to end with the Garmin 010-10580-00 Cable Coupler.

Garmin 8-Pin 10' Transducer Extension Cable.

Looking for a second Bail Mount for your 7" or 9"  Garmin echoMap DV or SV model?  Garmin's 010-12233-03 Bail Mount with Knobs is the exact Mount that came with your echoMap 7XDV, 7XSV and 9XSV Model. Includes quick cable disconnect feature allowing you to plug all necessary cords into the bracket for easy removal and re-install of your unit.

Garmin's mounting bracket enables you to mount your Garmin ECHOMAP UHD2 5- or 7-inch 'CV' series GPS. The Garmin bail mount is also compatible with select Garmin Striker fishfinders. See list below for full compatibility.

Garmin adapter cable connects an 8-pin transducer with XID to a 12-pin sonar port on compatible Garmin GPS / Fishfinder units.

Power your compatible Garmin Radar with this 48 foot long threaded cable.

The Garmin Marine Network Cable Connector gives you the ability to wire on the connector after you have run the cable through your boat.  Sold in a pack of two.

Control your Garmin Reactor Autopilot right from a remote. This rugged and water resistant remote provides the ultimate onboard control and convenience. Control steering and even use the remote for heading hold and course corrections! (compatible with Compact Reactor, Reactor 40 Steer by Wire and Reactor 40 Hydraulic)

Garmin Heavy Duty Transom Mount with Spray Shield

Get the latest software update available from Garmin echoMAP Series with this pre-programmed SD card.

Display Cover for ECHOMAP UHD2 72cv, 73cv, 74cv and 75cv GPS/Fishfinders.
Does Not work with Garmin Echomap Plus, UHD or UHD2 'sv' units

Display Cover for 9" ECHOMAP UHD2 SV units  - 92SV, 93SV and 94SV GPS/Fishfinders.
Does Not work with Garmin 9" Echomap Plus or UHD units

Mount your compatible Garmin LiveScope transducer to your Force Kraken trolling motor with this LiveScope mounting bracket. Conveniently route the LiveScope transducer cable through the shaft of the motor.

The Garmin GT12M-THF is a flush mount thru hull transducer with a 20-degree tilt, suitable for vessels with a deadrise of 16-24 degrees. The GT12M-THF is ideal for midsize fishing and cruising boats and features 350W mid-band CHIRP sonar.

Protective cover for Garmin Echomap Ultra 2 10" Displays. Compatible with Echomap Ultra 2 Displays Only!

Protective cover for Garmin Echomap Ultra 2 12" Displays. Compatible with Echomap Ultra 2 Displays Only!

The Garmin LiveScope Bulkhead Connector Kit allows you to flush mount your LiveScope extension cable for easy connection/disconnection of your LiveScope transducer.

Extend the cable length of your Garmin Panoptix LiveScope LVS32, LVS34 or XR LVS62 transducer with this extension cable. Cable is 3 feet long (1 meter).